Shinai Maintenance Information

Shinai Maintenance Information

The Shinai, or practice sword, was developed around 1750. It is constructed of four well-seasoned, highly polished staves of bamboo. A square piece of metal is wedged into a slot on the inside of the butt of each stave, to keep the staves aligned. A T-shaped rubber grommet separates the tips, which are covered by the sakigawa. The nakayui keeps the staves from spreading apart in the middle, and the tsuka serves both as handle and to bind the butt ends together. The himo (string) keeps the leather pieces bound together, and indicated the blunt side of the single-edged sword the shinai represents. The guard, or tsuba, is made of either plastic or whale skin and is held in place by a rubber grommet called the tsuba dome.

Disassembly

Remove the tsuba and tsuba dome. Untie the string at the handle. Pull off the handle. Pull off the sakigawa and nakayui with the string. This will save you the trouble of having to untie more knots than necessary. Hold onto the staves and mark the butt ends so you remember which is top, bottom, left and right. Then separate them, being careful not to lose the metal square near the butt end.

Preparation

Be sure to check your shinai before practice for any dangerous cracks or splinters in the staves! Using a sharp knife or the edge of a key round the edges of the top half of each stave, as shown. Apply a little bee’s wax, or spray furniture polish to the top third of each stave. Wipe this away after application, do not leave to soak in.

 

  1. Assemble the staves in the order that you marked on the butt ends; don’t forget to insert the metal square to keep them aligned. Slide the handle over the end to keep the assembly together while you work.
  2. Thread the string through the sakigawa as shown in figure A below; figure B is wrong and will tend to tear the leather. Leave about 2 inches, and tie a knot as shown in figures E and F.

Tie a single knot so that it ends up a little bit below the first bamboo joint of the staves.

Thread string through nakayui in either fashion shown here. Insert tip plug, then fit sakigawa over tip.

Tie string as shown.

  1. Tie a loop in the string as shown. The loop should be about 10cm from the leather loop in the handle. The string loop should be smaller than shown below, about 1/2”.Thread string through handle loop, and then back through itself as shown. Thread it back through the bottom of the leather loop and pull tight; cinch by winding around the loop a number of times and tucking through the last loop. Cut off any excess string.
  1. Tie the nakayui as shown. Cut off any extra length.